AC & MOTOR CONTROLLERS / AC CONTROLLER
AIR HANDLING UNIT CONTROLLER MODEK: AHU

3 phase supply
Air Handling Unit Controller

SPECIFICATIONS:

  • System:- 3 phase 4 wire 400 V AC, 50Hz +/- 15%.
  • Contact Rating: 3pole 16A contactor for compressor
    25 Amp MCB for compressor outputs,
  • Temperature Sensor: Thermistor Sensor NTC 10K @ 25°C Metal Body with Clamp.
  • Temperature Sensing Range: 0.0ºC to 50.0ºC.
  • Indications: AC ON indication for AC1, AC2 and AC3 .
    Fault indication for AC1, AC2 and AC3.
  • Frequency:-50 Hz / 60 Hz range (±5 Hz)
  • Measured Parameters:- 1] Voltage (Volt) Phase – Phase measured. (RMS)
    2] Unbalance Voltage measured Phase – Phase Unbalance measured.
    3] Current (Amps) Compressor1, Compressor2, Heater, Blower (3Ph 4 w).
    4] Room Temperature.
  • Protection:- 1] Over Voltage Protection (Settable)
    2] Under Voltage Protection (Settable).
    3] Over Load Protection (Settable).
    4] Under Load Protection (Settable).
    5] Unbalance (Settable)
    6] Reverse Phasing (Settable)
    7] Phase Failure Protection (Settable)
    8] High pressure (potential free input) (AC1/AC2)
    9] Low pressure (potential free input) (AC1/AC2)
    10] AHU Door Open (potential free input) (Blower/Master controller)
  • Auxiliary Power:- No External power is required (Draws power from the voltage signal Inputs)
  • Accuracy :- 1] Volt 0.25% rdg ± 1 dgts.
    2] Current 0.25% rdg ± 1 dgts.
  • Communication Output :-1] Serial port : RS 485
    2] Baud rate : Default: 9600
    3] Start bit : 1
    4] Stop bit : 1
    5] Protocol : MODBUS - RTU
  • Environmental:- 1] Working Temp : 0 to 55º C
    2] Storage Temp : 10 to 70º C
    3] Relative humidity : 0 – 95 % non-condensive

Specifications