AC & MOTOR CONTROLLERS / MOTOR CONTOLLERS
3P WATER LEVEL CONTROLLER WITH GSM-MPC-7

Salient Features:
1. Fully programmable
2. Suitable for three phase pumps up to 25HP.
3. Relay outputs for Star-Delta starters.
4. No auxiliary power supply required for controller operation.
5. Can be operated in 3 modes such as GSM/AUTO/MANUAL.
6. GSM based SMS controlled start/stop and remote monitoring.
7. GSM based Interactive Voice Response System (IVRS) controlled
start/stop and remote monitoring for 3 registered numbers.
8. IVRS – Voice response available in regional language.
9. Live Motor operation Status available via SMS as Motor ON/OFF
status, Live Fault, phase voltages and current drawn per phase
10. Inbuilt phone book for auto reply in case of faults.
11. Complete protection from electrical unhealthy condition.
12. All parameters are settable through front key.
13. LED indications for alarm (fault) & MOTOR ON.
14. Scrolling display of parameters, one by one in scroll mode.
15. Three bright 7 segment display on unit.
16. Inverse Time trip curve for over load fault.
17. It Will give Miss call AT Power ON.
The Motor protection unit continuously scans the faults like Under
Voltage, Over Voltage, SPP, Reverse Phase, Voltage Unbalance, Under Load,
Over Load, Current unbalance.

SPECIFICATIONS:

Technical Specification:
Input Supply: 3 Phase 415 V, 50 HZ AC (3 Phase 3 wire)
Accuracy:- 1] Voltage 0.25% ± 1 dgts.
2] Current 0.25% ± 1 dgts.
Output contact Rating:
7 A at 250 volt Relay.
Auxiliary Power: - No External power is required (Draws power from the
voltage signal Inputs)
GSM MODEM: Quad-Band 850/ 900/ 1800/ 1900 MHz
Environmental:
1] Working Temp : 0 to 55º C
2] Storage Temp : 10 to 70º C
3] Relative humidity: 0–95 % non-condensive
4] Warm up time : 30 Sec
Enclosure:-
1] Mounting : Surface mounting.
2] Position : Panel.
3] Terminal : Screw ON Terminals.
KEY’S:SET: This key is used to change the controller from RUN mode to
FUNCTION mode for Parameter setting & to save the modified setting in
Function mode
• INC: Up scroll the parameter & parameter value.
• DEC: Down scroll the parameter & parameter value.
LED’S:
1. PUMP ON (GREEN): MOTOR ON.
2 Voltage Fault (RED : SPP, Voltage Unbalance& Reverse Phase Fault.
3. UL (RED) : Under Load

4. OL (RED) : Over Load Fault.

Specifications