FLOW METER / ULTRASONIC FLOW METER
TWO WIRE INLINE ULTRASONIC FLOW METER - ATNSIONIC 100

ATNSIONIC 100 are micro-controller based 2 wire full bore type ultrasonic flow transmitters specially used for various industrial applications. These flow transmitters accurately measure the flow rate of conductive/ non conductive liquids in closed pipes. Due to its simple and rigid design, the flow transmitter is an obstruction-less and maintenance-free instrument in place of conventional mechanical flow measuring device. The use of ‘Transit Time’ technology offers highest ability and better measuring accuracy in the form of electrical signal 4-20 mA DC linearly proportional to volumetric flow.

 

SPECIFICATION: 

Media                                                    : Liquids

 

Viscosity                                             : 200 cp max

Line Size                                              : 50NB to 300NB

Type of Output                                  : 4 to 20mA DC, 2 wire HART Compatible

Display                                                 : LCD display - 5 digit for Flow Rate and 8 digit for Totalizer Flow

Calibration Range                             : As per requirement (Factory Calibrated for std. 2m/s velocity)

Accuracy                                             : +/- 0.5% M.V.(For 20 to 100% flow)

Linearity                                               : +/- 0.5% of M.V.

Repeatability                                      : +/- 0.2% of M.V.

Temperature Coefficient                : +/- 0.1% per °C

Process Pressure                             : 10 kg/cm² max

Material of construction                 : Lining - Rubber / PTFE

Flange -  MS / SS316

Sensor - SS 316

Power Supply                                    : 24 V DC

Power Consumption                        : < 40mW

Response Time                                 : <10 Sec

Electronics                                          : 1) Integral

2) Remote

Transmitter Enclosure                     : IP66

Process Connections                     : ANSI150 flanged, as per table B 16.5 (Other On Requirement)

Mounting                                             : In-Line Horizontal / Vertical

Operating Conditions                      : Temperature -20 to 75°C / Humidity 5 to 95% non condensing

Specifications