GMS BSED ELECTROMAGNETIC FLOW METER

Electromagnetic are micro-controller based 2 wire full bore type electromagnetic flow transmitters specially used for various industrial applications. These flow transmitters accurately measure the flow rate of conductive liquids and slurries in closed pipes. Due to its simple and rigid design, the flow transmitter is an obstruction-less and maintenance-free instrument in place of conventional mechanical flow measuring device. The use of ‘Pulsed DC’ technology offers highest ability and better measuring accuracy in the form of electrical signal 4-20 mA DC linearly proportional to volumetric flow, The instrument is based on Faraday’s law of electromagnetic induction. A magnetic field is generated by the instrument in the flow tube. The fluid flowing through this magnetic field generates a voltage that is proportional to the flow velocity and corresponding electrical output is provided with respect to ensuring voltage.

Media                                                     : Liquids (Conductive)

Conductivity                                       : > 5 µs/cm

Viscosity                                               : 200 cp max

Line Size                                                : 15 NB to 300 NB

Excitation                                             : Pulsed DC coil

Type of Output                                    : 4 to 20mA DC, GDM OUTPUT

Display                                                  : LCD display - 5 digit for Flow Rate and 8 digit for Totalizer Flow

Calibration Range                                : As per requirement (Factory Calibrated for std. 2m/s velocity)

Accuracy                                               : +/- 0.5% M.V.(For 20 to 100% flow)

Linearity                                               : +/- 0.5% of M.V.

Repeatability                                        : +/- 0.2% of M.V.

Temperature Coefficient                    : +/- 0.1% per °C

Process Temperature                         : -20 to 85° C max for Rubber Lining and -20 to 220°C for PTFE Lining

Process Pressure                              : 10 kg/cm² max (higher on request)

Material of construction                        : Lining - Neoprene Rubber/ Hard Rubber / EPDM / PFA / PTFE / CERAMIC

Flange                                                    : MS / CS / SS316 / SS304

Electrode                                              : SS 316L/ Hastalloy C / Platinum / Tantalum

Coil Housing                                        :SS/MS

Power Supply                                       : 24 V DC(Two wire)

Power Consumption                           : < 40mW

Response Time                                    : <10 Sec

Electronics                                           : Integral / Remote(Max. 2 meters)

Transmitter Enclosure                         : Electronics : IP66, Flow Tube : IP68

Process Connections                          : ANSI150 flanged, as per table B 16.5 (Other On Requirement)

Mounting                                              : In-Line Horizontal / Vertical

Operating Conditions                           : Temperature -20 to 75°C / Humidity 5 to 95% non condensing

Specifications

Pink printed dress, woven, round neck with a keyhole and buttoned closure at the back, sleeveless, concealed zip up at left side seam, belt loops along waist with slight gathers beneath, brand appliqu?? above left front hem, has an attached lining.

Comes with a white, slim synthetic belt that has a tang clasp.